Granulating machine operation notice:

First operators need to be serious and responsible work, in strict accordance with the granulating machine operation procedures, boot, downtime must be according to the program.

(1) dry steam, 0.3-0.4 kg pressure into conditioning;

(2) adjust the die roller distance. Average of 0.2 mm to 0.5 mm, can die with roller rotation, don't be too tight or too loose, too tight will shorten the life of die, would not bite SongYa roller;

(3) raw material moisture requirements, generally between 12% and 13%, after quenched and tempered material moisture 14% - 14.5%, must be uniform feed;

(4) the current load control by the regulation, absolutely can't overload production for a long time, this is the main cause of equipment damage;

5. Note that the normal production of granulating mechanical and electrical flow volatility, stop to check if it is abnormal;

6 new production equipment, granulating machine transmission case should work 500 hours continuous oil change, according to the production situation after oil change generally 3 to 6 months time, replace # - 120 # 68 # oil or 100 industrial gear oil;

All landowners resistance machine pelletizer, must SongYa roller, to die wall clean rear can restart, absolutely put an end to forced start under the blocked state, more is not allowed to use pipe wrench pull (gear shaft, granulating machine in normal working state, press roll need to 2 hours to add a lubricating grease;

Today often check the granulating machine wearing parts wear, avoid sudden fault and ring die cracking.

Ring die cracking reasons:

A, clamp under wear, not tight ring die; B, and the key to the transmission chuan wear molding line, molding cannot locate; C, spindle loose, produce the roller beat ring die; D, foreign body into the ring die; E, granulating machine ring die block and forcibly boot; F, ring die itself quality problems.